Skip to content

How To Auger Dig Through Concrete

There are a few ways to drill through concrete depending on the size of the hole you need. For small holes, a hammer drill with a masonry bit can be used. For larger holes, an auger drill can be used. An auger drill is a drill that has a screw-like mechanism that grabs onto the material and drills through it.

How To Auger Dig Through Concrete

There is no one definitive way to auger dig through concrete. Some common methods include using a gas-powered concrete saw, jackhammer, or drill; using a chisel and hammer; or using a chemical liquid to dissolve the concrete. Each method has its own set of pros and cons, and the best way to choose which one to use depends on the specific situation. For example, if there is limited space available or if the concrete is particularly thick, a drill may be the best

-Concrete auger -Tape measure -Chisel -Hammer -Safety goggles -Dust mask

  • Attach the auger bit to the drill
  • Keep drilling until you reach the desired depth
  • Position the drill at the desired location
  • Start drilling slowly and increase speed as you go

-Use a power drill with a concrete auger bit. -Slowly drill into the concrete, being careful not to hit any metal wires or pipes. -Keep drilling until you have a hole large enough to fit the auger bit through. -Fit the auger bit into the hole and start turning the drill. -Move the auger bit around until you break through to the other side of the concrete.

Frequently Asked Questions

Can An Auger Go Through Concrete?

An auger can go through concrete, but it depends on the size of the auger. A small auger may not be able to penetrate the concrete, while a large auger can easily cut through the concrete.

How Do You Dig Holes In Concrete?

There are a few ways to dig holes in concrete. One way is to use a jackhammer to break up the concrete. Another way is to use a drill with a concrete bit.

How Long Does It Take To Dig A Hole With An Auger?

It can take anywhere from a few minutes to a few hours to dig a hole with an auger, depending on the size of the hole and the type of auger.


Augering is a process of drilling a hole in concrete using an auger. This is done to create a path for wiring, plumbing, or other utilities. The process of augering through concrete can be difficult and time-consuming, but with the right tools and techniques it can be accomplished relatively easily.

Leave a Reply

Your email address will not be published.